Filter
Top Products
1-2 GENERAL INFORMATION
Before Servicing
Before starting to perform an inspection service or carry out a disassembly and reassembly opera-
tion on a m otorcycle, read the precautions given below. To facilitate actual operations, notes, illustra-
tions,
photographs, cautions, and detailed descriptions have been included in each chapter wherever
necessary. This section explains the items that require particular attention during the removal and
reinstallation or disassembly and reassembly of general parts.
Espec
ially note the following:
Battery Ground
Before completing any service on the motorcycle, discon-
nect t
he battery wires from the battery to prevent the engine
from accidentally turning over. Disconnect the ground wire
(−) first and then the positive (+). When completed with the
servi
ce, first connect the positive (+) wire to the positive (+)
terminal of the battery then the negative (−) wire to the neg-
ative terminal.
Edges of Parts
Lift large or heavy parts wearing gloves to prevent injury
from possible sharp edges on the parts.
Solvent
Use a high flush point solvent when cleaning parts. High
flush point solvent should be used according to directions
of the solvent manufacturer.
Cleaning vehicle before disassembly
Clean the vehicle thoroughly before disassembly. Dirt or
other foreign materials entering into sealed areas during ve-
hicle disassembly can cause excessive wear and decrease
performance of the vehicle.