Filter
Top Products
APPENDIX 17-11
Cable, Wire, and Hose Routing
1. Clamp all the wires as shown in the encircled area.
2. Meter
3. Take ou
t the lead of the meter from the right side of the tie lap to connect with the meter.
4. Clutch cable
5. Starter cable
6. To fro
nt left turn signal light (Run the harness above the bolt for fairing installation.)
7. Run the ignition switch lead front the clutch cable and starter cable.
8. To left switch housing
9. Run t
he leads for the clutch starter and the ignition switch in order from the head pipe then run
the cables with their acceleration side facing outward.
10. Headlight high and low
11. Inst
all the lead with its inner side facing inward.
12. Running position light
13. To right switch housing
14. Thr
ottle cable (Run the cable through the front of main harness.)
15. Brake hose (to caliper right side)
16. To front right turn signal light (Run the harness above the bolt for fairing installation.)
17. Sea
tlock
18. Seat lock cable