Filter
Top Products
PERIODIC MAINT EN ANCE 2-29
Periodic Maintenan ce Procedures
Engine Lubrication System
Engine Oil Change
•
Sit
uate the motorcycle so that it is vertical after warming
up the engine.
•
Remove the engine drain plug [A] to drain the oil.
○
The
oil in the oil f ilter can be drained by removing the filter
(see Oil Filter Change).
Replace the drain plug gasket [B] with a new one if it is
da
maged.
•
Tighten the drain plug.
Torque - Engine Drain Plug: 20 N·m ( 2.0 kgf·m, 14.5 ft·lb)
•
Pour in the specified type and amount of oil.
Engine Oil
Grade: API SE, SF or SG
API SH or SJ with JASO MA
Viscosity: SAE 10W–40
Amount:
3.1 L (3.3 US qt) (whe n filter is not removed)
3.3 L (3.5 US qt) (w he n filter is remove d)
3.8 L (4.0 US qt) ( when engine is completely
dry)
NOTE
○
Depending on the atmospheric temperature of your rid-
ing area, the engine oil viscosity should be changed ac-
cording to the chart.
Oil Filter Change
•
Drain the engine oil (see Engine Oil Change).
•
Remove:
Lower Fairing (see Frame chapter)
•
Remove the oil filter [A] with the oil filter w rench [B].
Special Tool - Oil Filter Wrench: 57001–1249
•
Replace the filter with a new one.
•
Apply engine oil to the gasket [A] before installation.
•
Tighten the filter with the oil filter wrench.
Torque - Oil Filter (P/No. 16097–1070): 27 N·m (2.8 kgf·m,
20 ft·lb)
Oil Filter (P/No. 16097–0002): 31 N·m (3.2 kgf·m,
23 ft·lb)
NOTE
○
Hand tightening of the oil filter can not be allowed since
it does not reach to this tightening torque.
•
Pour in the specified type and amount of oil (see Engine
Oil Change).