Filter
Top Products
SUSPENSION 13-15
Front Fork
•
Install the cente ring plate on the c ylinder unit.
•
Insert the cente r ing plate and cylinder unit as a set into
the inner tube.
Cylinder Unit [A] and Center Ring Plate [C] for Right Fork
Leg
Cylinder Unit [B] and Center Ring Plate [C] for Left Fork
Leg
•
Hold the front fork in a vise.
•
Torque the Allen bolt.
Torque - Front Fork Bottom Allen Bolt: 20 N·m (2.0 kgf·m,
15 ft·lb)
•
Pour in the specified type of oil (see Fork Oil Change.)
Inner Tube, O uter Tube Inspection
•
Visually inspect the inner tube [A], and repair any dam-
age.
•
Nick or rust damage can sometimes be repaired by using
a wet-stone to remove sharp edges or raised areas which
cause seal damage.
If the dam age is not repairable, replace the inner tube.
Since damage to the inner tube damages the oil seal,
replace the oil seal whenever the inner tube is repaired
or replaced.
C
AUTION
If the inner tube is badly bent or creased, replace
it. Excessive bending, followed by subsequent
straightening, can weaken the inner tube.
•
Temporarily assemble the inner tube [A] and outer tube
[B], and pump [C] them back and forth manually to check
for smooth operation.
If you feel binding or catching, the inner and outer tubes
must be replaced.
WARNING
A straightened inner or outer fork tube may fall in
use, possibly causing an accident. Replace a badly
bent or damaged inner or outer tube and inspect the
other tube carefully before reusing it.
Dust Seal Inspection
•
Inspect the dust seals [A] for any signs of deterioration or
damage.
Replace it if necessary.