Kawasaki Z1000 Motorcycle User Manual


 
APPENDIX 17-5
Cable, Wire, and Hose Routing
1. Clutch cable
2. Meter ground
3. Clamp (
Ignition switch connector)
4. Ignition switch connector
5. Inlet air pressure sensor
6. To ign
ition coil
7. Fan motor connector (Connect the con-
nector on the inlet air pressure sensor.)
8. Clam
p
9. To fuel pump
10. To fuel level gauge and fuel reserve
swit
ch
11. To pickup coil and oil pressure switch
12. Insert the clamp of mainharness into the
fla
me hole.
13. Mainharness
14. Starter relay
15. To r
ear brake switch
16. Connect the battery negative cable and
battery.
17
.
Ba
ttery negative cable
18. Self-diagnosis indicator terminal
19. Turn signal relay
20
.
Fu
el pump relay
21. ECU main relay
22. License light connector
2
3.
T
ail light connector
24. Rear right turn signal light connector
25. Rear left turn signal light connector
2
6.
A
tmospheric pressure sensor
27. Bracket
28. ECU fuse
29. Junction Box
30. ECU
31. Run the lead of ECU under the end sur-
face of battery case.
32. Battery Positive Cable (to starter r elay)
33. Regulator/rectifier
34. Vehicle-down sensor
35. Inlet air temperature sensor
36. Side stand switch
37. Neutral Switch
38. Speed sensor
39. Altern
ator
40. Engine harness
41. Water temperature sensor
42. Run th
e lead of ignition switch above the
hose connected with the thermostat body,
and the front of inlet air pressure sensor
as we
ll.
43. Frame ground (with thermostat)
44. To cam sensor, fan switch, horn
45. The h
arness passes on the clutch cable.
46. Battery case
47. Damper
48. Fro
nt
49. Run the brake hose between upper
bracket and clamp of bracket.
50. Run
the Throttle Cable together with the
Right Grip Switch wire through the of
Cowl Bracket clamp.
Ru
n the wire thought the center of the
frame, which has to be located nearer to
the center than the cable.
51
.
Ri
ght switch housing lead
52. Run the Clutch Cable, the Starter Cable
and the Left Grip Switch wire through the
s
pace made between the Cowl Bracket
clamp and the Upper Bracket.
Run the Main Harness under the right
s
ide of the thermostat body.
53. Left switch housing lead
54. Starter cable
5
5.
R
un the s tarter cable through under the
throttle cable.
56. Run the clutch cable between the water
hose and the mainharness.
57. Throttle cable (decelerator)
58. Throttle cable (accelerator)
59. No slip of cable
60. Band (near of the air cleaner duct holder
screw)