6-8 CLUTCH
Clutch Cover
•
Fit the spring [A] as shown.
[B] Viewed from Rear
[C] Rel
ease Shaft
[D] Clutch Cover
Clutch Cover Disassembly
•
Remove:
Oil Seal [A]
Needle Bearings
•
Remove:
Circlip [A]
Special Tool - Inside Circlip Pliers [B]: 57001–143
•
Remove:
Oil Level G auge [C]
Clutch Cover Assembly
•
Replace the needle bearings and oil seal with new ones.
NOTE
○
Install the needle bearings so that the manufacture’s
mark face out.
•
Install the needle bearings [A] and oil seal [B] position as
shown.
[C] Press the bearing until the bottom.
[D] Press the bearing so that the bearing surface is flush
with the housing end of clutch cover [E ].
•
Apply water to the rubber of the oil gauge [A] and press it
so that the projections [B] f ace inside.
•
Install a new circlip so that the circlip ends [C] do not wrap
over the projection [D].