ENGINE REMOVAL/INSTALLATION 8-7
Engine Removal/Installation
•
Remove:
Camshaft Position Sensor Connector [A]
Injector Harness Connector [B]
Coolant Reserve Tank [A] ( see Cooling System chapter)
Air Cleaner Housing Bolt [B]
Vacuum Switch Valve Hose [C]
•
Remove:
Vacuum Switch Valve Tube [A]
Inlet Air Pressure Sensor Tube [B]
Throttle Body Assy [C]
○
Loosen the #1,2 body assy clamps [D] and pull the throttle
body out of the holders, and then remove it to the left side.
Special Tool - Carburetor Drain Plug Wrench, Hex3:
57001–1269
•
Remove:
Breather Hose End [A]
•
Remove:
Nuts [A]
Clamp Bolts [B]
Exhaust Pipe Assy [C]