Kawasaki Z1000 Motorcycle User Manual


 
ELECTRICAL SYSTEM 16-41
Ignition System
Camshaft Position Sensor Peak Voltage Inspection
Remove:
Fuel Tank (see Fuel System (DFI) chapter)
Camshaft Position Sensor Lead Connector [A] (discon-
nect)
Set the hand tester [B] to t he 10 V DC range.
Connect the peak voltage adapter [C] to the hand tester
and Camshaft Position Sensor leads in the connector.
Speci
al Tool -
Hand T
ester: 57001–1394
Recommended Tool- Peak Voltage Adapter
Type: KEK-54-9-B
Bran
d: KOWA SEIKI
Connections:
Camshaft Position
Sensor Lead
Adapter Hand Tester
Black
Red
(+)
Yellow
Black
(–)
T urn the ignition switch and engine stop switch on.
Pushing the starter button, turn the engine 4 5sec-
onds with the transmission gear in neutral to measure the
Camshaft Position Sensor peak voltage.
Repeat the m easurement 5 or m ore times.
Camshaft Position Sensor Peak Vo ltage
Standard:
0.2 V or more
If the peak voltage is lower than the standard, inspect the
Camshaft Position Sensor.
Stick Coil (Ignition Coil together with Spark Plug Cap)
Removal
Remove the fuel tank (see Fuel System (DFI) chapter).
Unscrew the thermostat bracket bolt [A].
If removing the stick coil #2 or #3.
Disconnect the stick coil connectors [A].
Pull the stick coil #1 [B] off the spark plug.
Take out the camshaft position sensor connector [ C] from
the bracket (see Camshaft Position Sensor Removal).
Pull the stick coil #2 [D] off the spark plug.
CAUTION
Do not pry the connector part of the coil while re-
moving the coil.