Filter
Top Products
CLUTCH 6-11
Clutch
•
Apply molybdenum disulfide grease to the pusher ends
[A] and install the pusher [B].
•
Apply engine oil t o the needle bearing [C] and install it.
•
Install the washer [D].
•
Align the mark [A] of the clutch spring plate [B] with the
groove [C] of the clutch hub.
•
Install the clutch spring plate and spring, and tighten the
clutch spring bolts.
Torque - Clutch Spring Bolts: 8.8 N·m (0.9 kgf·m, 78 in·lb)
•
Install the clutch cover (see Clutch Cover Installation).
Clutch Plate Assembly Inspection
•
Inspect the friction plate thickness (see Clutch Plate,
Wear, Damage Inspection).
•
Measure the length [A] of the clutch plate assembly as
shown.
○
Assemble:
Clutch Hub [B]
Spring Seat [C]
Spring [D]
Friction Plates [E]
Steel Plates [F]
Spring Plate [ G]
Springs [H]
Spring Holders [I]
Spring Bolts [J]
Torque - Clutch Spring Bolts: 8.8 N·m (0.9 kgf·m, 78 in·lb)
Clutch Plate Assembly
Standard: 48.4 ∼ 49.0 mm (1.91 ∼ 1.93 in.)
If the length is not within the specified range, adjust the
length (see Clutch Plate Assembly Adjustment).