Filter
Top Products
COOLING SYSTEM 4-17
Hose and Pipes
Hose Installation
•
Install the hoses and pipes, being careful to follow bend-
ing direction. Avoid sharp bending, kinking, flattening or
twisting.
•
Run the hoses in accordance w ith the Cable, Wire, and
Hose Routing section in the Appendix chapter.
•
Wet the internal diameter of both ends of the water hose
with water or c oolant and install the hose onto the pipe.
•
Install the clamp [A] as near as possible to the hose end
to clear the raised rib of the fitting. This will prevent the
hoses from working loose.
○
The clamp screws should be positioned correctly to pre-
vent the clamps from contacting the other parts.
Torque - Hose Clamp Screws: 2.0 N·m (0.2 kgf·m, 1 7 in·lb)
Hose Inspection
•
Refer to t he Cooling System in the Periodic M aintenance
chapter.