Filter
Top Products
ELECTRICAL SYSTEM 16-69
Meter, Gauge, Indic ator Unit
•
If the oscillator is not available, the speedometer can be
checked as follows.
○
Install the meter unit.
○
Raise the rear wheel off the ground, using the jack.
○
Turn on the ignition switch.
○
Rotate the rear wheel by hand.
○
Check that the speedometer shows the speed.
If the speedometer does not work, check the speed sen-
sor electric source voltage and speed sensor.
The electric source voltage and speed sensor are normal,
replace the meter assembly.
Speed Sensor Electric Source Check:
•
Connect the 12 V battery and terminals in the same man-
ner as specified in the "Liquid Crystal Display (LCD) Seg-
ments Check".
•
Set the hand tester to the DC25 V range and connect it to
the terminals [12] and [9].
If the voltage is less than 8 V, replace the meter assembly.
Odometer Check:
•
Check the odometer with the speedometer in the same
way.
If value indicated in the odometer is not added, replace
the meter assembly.
NOTE
○
The data is maintained even if the battery is discon-
nected.
○
When the figures come to 999999, they are stopped and
locked.
Trip Meter Check:
•
Check the trip meter with the speedometer in the same
way.
If value indicated in the trip meter is not added, replace
the meter assembly.
•
Check that when the RESET button is pushed for more
than tw o seconds, the figure display turns to 0.0.
If the figure display does not indicate 0.0, replace the me-
ter assembly.