FINAL DRIVE 11-9
Drive Chain
•
Turn wrench clockwise until tip of r iveting pin hits of link
pin.
•
Rivet it.
•
Some work for the other link pin.
•
After staking, check the staked area of the link pin for
cracks.
•
Measure the outside diameter [A] of t he link pin and link
plates outside width [B].
Link Pin Outside Diameter
Standard: 5.6 ∼ 6.0 mm (0.22 ∼ 0.24 in.)
Link Plates Outside Width
Standard: 19.85 ∼ 20.00 mm (0.781 ∼ 0.787 in.)
If the reading exceeds the specified length, cut and rejoin
the chain again.
•
Check:
Movement of the rollers
•
Adjust the drive chain slack after installing the chain (see
Drive Chain Slack A djustment in the Periodic Mainte-
nance chapter).