Filter
Top Products
FINAL DRIVE 11-11
Sprocket, Coupling
Rear Sprocket Removal
•
Remove the rear wheel (see Wheels/Tires chapter).
CAUTION
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so that the disc does
not touch the ground.
•
Remove the rear sprocket nuts [A].
•
Remove the rear sprocket [B].
Rear Sprocket Installation
•
Install the sprocket facing the tooth number marking [A]
outward.
•
Tighten the rear sprocket nuts.
Torque - Rear Sprocket Nuts : 59 N·m (6.0 kgf·m, 43 ft·lb)
•
Install the rear wheel (see Wheels/Tires chapter).
Coupling Bearing Removal
•
Remove:
Coupling
Grease Seal
Circlip [A]
•
Remove the bearing [A] by tapping from the wheel side.
Special Tool - Bearing Driver Set: 57001–1129 [B]
Coupling Bearing Installation
•
Replace the bearing with a new one.
•
Press in the bearing [A] until it is bottomed.
Special Tool - Bearing Driver Set: 57001–1129 [B]
•
Pack the bearing with high temperature grease.
•
Replace the circlip with a new one.