Filter
Top Products
2-20 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
•
Clean the element by tapping it lightly to loosen dust.
•
Blow away the remaining dust by applying compressed
air [A]
from the outside to the inside (from the clean side
to the dirty side).
•
Visually inspect the element f or no tears or no breaks and
inspe
ct the sponge gaskets [B] also.
If the element or gasket has any tears or breaks, replace
the element.
•
Install the element [A] with the flat side [B], facing for-
wards.
•
Fit the tongue [C] of the air cleaner duct holder into the
slot of the housing the air cleaner duct holder.
Front [D]
Torque - Air Cleaner Duct Holder Screws: 3.8 N·m (0.39
kgf·m, 34 in·lb)
Evaporative Emission Control System Inspection
(CAL)
•
Inspect the canister as follows:
○
Remove the rear seat (see Frame chapter).
○
Remove the band [A] and hoses and take out the canister
[B].
○
Visually inspect the canister for cracks and other damage.
If the canister has any cracks or bad dam age, replace it
with a new one.
NOTE
○
The canister is designed to work well through the motor-
cycle’s life without any maintenance if it is used under
normal conditions.
○
Connect the purge hose (green) [C] and the canister
breather hose (blue) [D] to the canister as shown.
○
Install the canister with the inlet [E] down and the rear seat
(see Frame chapter).
Front [F]
•
Check the liquid/vapor separator as follows:
•
Remove the left frame cover [A].