Kawasaki Z1000 Motorcycle User Manual


 
16-44 ELECTRICAL SYSTEM
Ignition System
WARNING
To avoid extremely high voltage shocks, do not
touch the spark plugs or tester connections.
Turn the ignition switch and the engine stop switch ON.
Pushing the starter button, turn the engine 4 5 seconds
with the transmission in neutral to measure the primary
peak voltage.
Repeat the measurements 5 times for one stick coil.
Stick
Coil Primary Peak Voltage
Stand
ard: 88 V or more
Repeat the test for the other stick coil.
If the reading is less than the specified value, check the
following.
Stick Coils (see Stick Coil Inspection)
Crankshaft Sensor (see Crankshaft S ensor I nspection)
If the stick coils, and crankshaft sensor are normal, check
the ECU (see Fuel System (DFI) chapter).
Spark Plug Removal
Refer to the Electrical System in the Periodic Mainte-
nance chapter.
Spark Plug Installation
Refer to the Electrical System in the Periodic Mainte-
nance chapter.
Spark Plug Cleaning and Inspection
Refer to the Electrical System in the Periodic Mainte-
nance chapter.
Spark Plug G ap Inspection
Refer to the Electrical System in the Periodic Mainte-
nance chapter.