Filter
Top Products
E-93
Average Measurement
3
Make sure that (Ready to measure) is
displayed or Ready lamp is green, and then
press the measuring button.
The number of completed measurements and the measured
value will be displayed during measurement.
M
emo
To cancel the measurement, press the [TARGET] (Cancel)
button. If canceled, the measurement will not be saved.
4
Place the specimen measuring port at the next
position and repeat the steps from 1 to 3.
When the specified number of measurements has been
completed, the averaging result will be displayed on the
screen.
M
emo
• To finish manual averaging and display the result before the specified number of measurements is completed,
press the [SAVE/SEL] button.
• When the screen is turned OFF by the power save function, press any of the measuring or control buttons to turn
ON the screen, confirm that (Ready to measure) is displayed or Ready lamp is green, and then press the
measuring button.