Filter
Top Products
E-74
Other Settings
Initialization
Reset the settings of the instrument to the initial status.
Note
• Do not initialize the instrument unless necessary.
• The measured data, target color data, tolerances set to each target color and default tolerance settings will be
protected and not be deleted by initialization.
M
emo
The measured data and target color data which you saved will be stored even after initialization.
For details of the initial setting values, refer to page E-128 “Initial Settings”.
[Setting Procedure]
1
Turn ON the instrument while holding down
the [TARGET] and [SAMPLE] buttons simulta-
neously.
The <Initialize> screen is displayed.
2
Use the or button of the cross key to
move the cursor to “OK” and then press the
[SAVE/SEL] button.
Initialization will be performed.
M
emo
When you place the cursor on “Cancel” on the <Initialize> screen and press the [SAVE/SEL] button, the
initialization is canceled and the <Calibration> screen is displayed.
SAMPLE TARGET
CAL
SAVE
SEL