Filter
Top Products
E-86
Measured Data Operation
Scan Name
You can scan a “name” of the measured data with a Bluetooth bar code scanner and set it as the data
name.
• First, you need to establish the Bluetooth connection between the instrument and bar code scanner.
• There are two methods of the Scan Name function: “Auto Scan” and “Manual Scan”.
Auto Scan: The bar code scanner automatically reads a “name” for each measurement.
Manual Scan: The user invokes “Scan Name” from the <Menu> screen and reads a “name” with the
bar code scanner.
M
emo
• For the method of establishing the Bluetooth connection with the bar code scanner, refer to page E-111 “Connecting
a Bar Code Scanner”.
• For the method of switching between Auto Scan and Manual Scan, refer to page E-116 “Setting Auto Scan”.
Note
• If the Bluetooth connection is improper, “Scan Name” cannot be selected on the <Menu> screen.
• Although the Bluetooth connection is established, the input may be disabled in the case when the Scan Name
operation is attempted while the bar code scanner is turned off.
When Auto Scan is Set
When the Scan Name method is set to “Auto Scan”, the bar
code scanner automatically reads a “name” for each
measurement.
M
emo
• Pressing the [Cancel] (Back) button cancels the name reading.
Note
When the bar code scanner fails reading a name, an error message
appears to prompt the user to read the name with “Manual Scan”.
M
emo
For instructions of the Manual Scan, refer to page E-87 “When
Manual Scan is Set”.