Filter
Top Products
E-38
Condition Setting
Color Index
Select the index (WI, YI, etc.) to be used.
[Setting Procedure] Start the procedure from the <Disp. Cond.> screen.
1
Use the or button of the cross key to
move the cursor to “Color Index” and then
press the [SAVE/SEL] button.
The <Color Index> screen is displayed.
2
Use the or button of the cross key to
move the cursor to the desired item.
Settings
❍None
❍WI (E313-73): Whiteness index (ASTM E313-73)
❍WI (E313-96): Whiteness index (ASTM E313-96)
❍YI (E313-73): Yellowness index (ASTM E313-73)
❍YI (D1925): Yellowness index (ASTM D1925)
❍ISO Bright.: ISO Brightness
❍8° Gloss: The gloss value calculated with the specular
reflection in the direction of 8. °. This value can be used
for relative management of glossiness.
M
emo
• A value for WI (E313-73) is displayed only when observer 2° and illuminant “C” are selected.
• A value for WI (E313-96) is displayed only when illuminant “C”, “D50” or “D65” is selected.
• A value for YI (E313-73) is displayed only when observer 2° and illuminant “C” are selected.
• A value for YI (E313-96) is displayed only when observer 2° and illuminant “C” are selected.
• A value for 8° Gloss is displayed only when “I+E” for specular component mode is selected.
3
Press the [SAVE/SEL] button.
The selection is confirmed and the screen returns to the <Disp. Cond.> screen.
Note
If you press the [TARGET] (Back) button without pressing the [SAVE/SEL] button, you return to the
<Disp. Cond.> screen without changing the setting.