Filter
Top Products
E-118
Displaying the Instrument Information
Showing/Hiding the Annual Service Recalibration Recommendation Message
When about one year passes after the factory shipment or the calibration service (or maintenance)
conducted by KONICA MINOLTA-authorized service facility, the CM-700d/600d shows a message
“WR050 Annual service recalibration recommended.” at start-up to recommend annual service
recalibration.
You can set this message display to be shown or hidden.
Note
Although the annual service recalibration recommendation message display can be hidden, it is recommended to
accept our recalibration service.
M
emo
The message display is set to “Show” before the factory shipment.
You can set the annual service recalibration recommendation message display when you turn on the
instrument as in the procedure below.
[Operating Procedure] Start the procedure when the instrument is turned off.
1
Hold down the [CAL] button and turn ON the instrument.
• Keep holding down the [CAL] button until the <Calibration> screen
appears.
The show/hide status of the annual service recalibration recommendation
message is toggled by this operation.
Checking the Message Display Setting
You can check whether the annual service recalibration recommendation message display is set to show
or hide by displaying the instrument information.
M
emo
For the method to show the instrument information, refer to page E-117 “Displaying the Instrument Information”.
When the annual service recalibration recommendation message
display is set to “Show”
The model name, version, serial number, and the month/year when the
next annual service recalibration recommendation message will be
displayed are displayed.
When the annual service recalibration recommendation message
display is set to “Hide”
The model name, version, and serial number are displayed.
[CAL] button