Filter
Top Products
E-44
Condition Setting
Wait Time
Specify the delay between the press of the measuring button and the flash of the lamp.
[Setting Procedure] Start the procedure from the <Meas. Cond.> screen.
1
Use the or button of the cross key to
move the cursor to “Wait Time” and then
press the [SAVE/SEL] button.
The <Wait Time> screen is displayed.
2
Use the or button of the cross key to
specify a value.
• Use the or button of the cross key to move the
cursor to the digit on the left or right.
Setting
❍Sec. [0.0 to 3.0]:
To eliminate the influence of instrument shake, provide a
period between the press of the measuring button and the
flash of the lamp for measurement in increments of 0.1
seconds. When 0.0 seconds is specified, measurement
starts immediately.
3
Press the [SAVE/SEL] button.
The selection is confirmed and the screen returns to the
<Meas. Cond.> screen.
Note
If you press the [TARGET] (Back) button without pressing the [SAVE/SEL] button, you return to the
<Meas. Cond.> screen without changing the setting.