Filter
Top Products
E-77
Displaying the Measurement Results
At the end of measurement, the measurement results will be displayed on the LCD according to the
specified measurement conditions. Typical measurement result screens are shown below.
M
emo
You can switch the measurement result screens with the or button of the cross key. For details of the screen
switching, refer to page E-80 “Switching the Display Contents of the Measurement Results”.
Measured Data
The figure below shows a sample screen where “Abs. & Diff.” is selected for “Disp. Type” of the display
condition.
1 Data No. of the currently selected target color data.
2 Current lens position (M: MAV, S: SAV)
• With the CM-600d, only “MAV” can be used.
3 Current specular component mode (I: SCI, E: SCE, I+E: SCI + SCE)
4 Ready to measure
5 Bluetooth mode is ON.
6 White calibration completed
7 Measured data (Can be switched with the or button of the cross key.)
• When both illuminants 1 and 2 are set, the measurement results for both illuminants are displayed.
The results of the measurement using illuminant 1 are displayed on the left, and the results using
illuminant 2 are displayed on the right.
• The measured data which failed the pass/fail judgment based on the color difference tolerance will
be highlighted in red.
8 Date and time of the measurement
9 Data No. of the target color data used for the measurement
10 Lens position and specular component mode used for the measurement
11 Indicates that pressing the [MENU] button will display the <Menu> screen.
1 23456
11
10
7
9
8