Polycom RealPresence Resource Manager System Operations Guide Discontinue Redundancy
524 Polycom, Inc.
Discontinue Redundancy
In some circumstances, you may need to discontinue redundancy.
To discontinue a redundant Polycom Resource Manager system
configuration when the system is in a valid redundant state:
Use this procedure to discontinue redundancy, but only when the system is in
a valid redundant state.
1 Log into the system using the virtual IP address.
2 Go to Admin > Server Settings > Redundant Configuration.
3 On the Redundant Configuration page, click Reset Redundant
Configuration.
The two servers restart as single server.
To discontinue a redundant Polycom Resource Manager system
configuration if only on server can be accessed:
If only one server can be accessed, discontinue redundancy on that server first.
Discontinue redundancy on the other server after it can be accessed
1 Log into the system using the virtual IP address.
2 Go to Admin > Server Settings > Redundant Configuration.
3 On the Redundant Configuration page, click Reset Redundant
Configuration.
The primary system restarts as single server.
4 When the redundancy server can be accessed (Now it promotes to active
server), log into the system using the virtual IP address.
5 Go to Admin > Server Settings > Redundant Configuration.
6 On the Redundant Configuration page, click Reset Redundant
Configuration.
The system restarts as single server.
