Available Settings for a Site Provisioning Profile Using Site Provisioning Profiles
Polycom, Inc. 237
Table 16-2 Provisioning Fields Used for the RealPresence Access Director
system.
Field For the RealPresence Access Director at the site being provisioned...
RPAD Settings are available when the site associated with the profile has been enabled for use with a
RealPresence Access Director system (When the Enabled for RPAD check box is marked).
RPAD Settings
Time Server Specify whether to connect to a time server for automatic system time settings.
Select Auto to require that the video endpoint system synchronize with an external
time server that is identified by a network domain controller. Because it is identified
by a network domain controller, you do not need to enter the IP address of the time
server.
Select Manual to require that the video endpoint system synchronize with an external
time server that may not be identified by a network domain controller. In this case,
you must also enter the IP address of the time server in the Time Server Address
field.
If Time Server is set to Off, or if the Time Server is set to Manual or Auto but the
endpoint system cannot connect to the time server, the date and time must be
manually reset at the endpoint.
Primary Time Server
Address
Specify the address of the primary time server when Time Server is set to Manual.
Secondary Time
Server Address
Specify the address of the secondary time server when Time Server is set to Manual.
Provision Polling
Interval
Specify the frequency at which the RealPresence Access Director system polls the
RealPresence Resource Manager system for new provisioning information.
By default, this interval is 60 minutes. For performance reasons, the minimum positive
value for this interval is 5 minutes. There is no maximum value enforced. When the
value of this interval is set to 0, the RealPresence Resource Manager does not poll
the RealPresence Resource Manager system for new provisioning information.
Heartbeat Posting
Interval
Specify the frequency at which the RealPresence Access Director systems poll the
Resource Manager system for a heartbeat.
Server Status Posting
Interval
RPAD Settings 2
RPAD Settings 2 is available when the site associated with the profile has been enabled for use with a
RealPresence Access Director (Enabled for RPAD).
Enable IP H.323 Specify whether to enable IP H.323 calls.
Gatekeeper IP
Address
When Use Gatekeeper is set to Specify, enter the Polycom DMA signalling IP
address in this field.
Enable SIP Specify whether to enable SIP calls.
