Available Settings for a Site Provisioning Profile Using Site Provisioning Profiles
Polycom, Inc. 233
Enable RSVP Allows the endpoint system to use Resource Reservation Setup Protocol (RSVP) to
request that routers reserve bandwidth along an IP connection path. Both the near
site and far site must support RSVP in order for reservation requests to be made to
routers on the connection path.
Enable Dynamic
Bandwidth
Specify whether to let the endpoint system automatically find the optimum line speed
for a call.
Maximum Transmit
Bandwidth (Kbps)
Specify the maximum transmission line speed.
Maximum Receive
Bandwidth (Kbps)
Specify the maximum reception line speed.
Security Settings
Security Profile Read-only field. Displays the security level of the Resource Manager system.
Use Room Password
for Remote Access
Specify whether the local endpoint system password and remote access password
are the same.
Room Password Enter or change the local endpoint system password here.
When the local password is set, you must enter it to configure the system Admin
Settings using the remote control. The local password must not contain spaces.
Administrator ID Enter the administrative account that should be used to access the endpoint system
remotely.
Remote Access
Password
For endpoint systems, enter or change the remote access password here.
When the remote access password is set, you must enter it to upgrade the software
or manage the endpoint systems from a computer. The remote access password
cannot include spaces.
Meeting Password Specify the password users must supply to join multipoint calls on this endpoint
system if the call uses the internal multipoint option, rather than a bridge.
This field can also be used to store a password required by another endpoint system
that this system calls. If a password is stored in this field, you do not need to enter it at
the time of the call; the endpoint system supplies it to the system that requires it. The
meeting password cannot include spaces.
Enable Web Access Specify whether to allow remote access to the endpoint system by the web.
Note
The endpoint systems will restart if the remote access settings are changed. This
setting does not deactivate the associated port, only the application. Use the Web
Access Port setting to disable the port.
Table 16-1 Available Settings for a Site Provisioning Profile
Field For the endpoint systems at the site being provisioned...
