Filter
Top Products
8-8 CRANKSHAFT / TRANSMISSION
A. Set Pin
B. Set Rings
c. Oil Passage
A. Oil Return Hose Clamp
.Apply engine oil to the transmission gears, ball bearings,
shift drum, and crankshaft main bearing inserts.
.Apply liquid gasket -black and silicone sealant as
shown in the figure below.
.Tighten the crankcase mounting bolts following the
tightening sequence to the specified torque (see
Exploded View).
O Following the tightening sequence, tighten the 8 mm
bolts first to about one half of the specified torque, and
finally to the specified torque.
O Tighten the 6 mm bolts to the specified torque.
Lower Crankcase
@
fFC
~
~
~ !:1'=F1R ~
~~
@~
rlIO~
:?>
0
D
18
)
a
~
A. <!>8 x L95 mm
B. <!>8 x L90 mm
c. <!>6 x L40 mm
C1 : Liquid Gasket -Silver (Kawasaki Bond:
92014-002)
~ : Silicone Sealant ( Kawasaki Bond: 56019-120)
Apply silicone sealant upon liquid gasket.
.Install the crankshaft, shift drum and transmission.
.Set the grip of clamp backward at the crankcase.