Filter
Top Products
WHEELS / TIRES 9-7
Rim Runout
O Check that the blade and weight seat fully on the rim
flange, and that the clip is hooked over the rim ridge and
reaches rim flat portion.
If the balance weight has any play on the rim flange.
the blade and/or clip have been stretched. Replace the
loose balance weight.
Do not reuse used balance weight.
Balance Weight
Part Number
41075-1014
41075-1015
41075-1016
Weight(grams)
10
20
30
Installing Balance Weight
(a) Press or lightly hammer the weight in,
1 .Radial Runout 2. Axial Runout
*If rim runout exceeds the service limit, check the wheel
bearings (see this chapter).
* If the problem is not due to the bearings, the wheel must
be replaced.
Axial Runout
Service Limit: O.5mm
O.8mm
Radial Runout
Service Limit:
Balance Weight Installation
.Check if the weight portion has any play on the
blade-and-clip plate.
* If it does, discard it.
.Lubricate the balance weight blade, tire bead, and rim
flange with a soap and water solution or rubber
lubricant. This helps the balance weight slip onto the
rim flange.
.Install the balance weight on the rim.
O Slip the weight on the rim flange by pushing or lightly
hammering the weight in the direction shown in the
figure.