Filter
Top Products
ENGINE TOP END 4-23
Carburetor Holders
M uffler
Removal
.Remove the following.
Clamps
Allen Bolts
.Remove the inlet pipes.
Removal
.Remove the following.
Lower Fairing
Radiator {Do not remove the hoses and not drain
coolant.)
.Remove the nuts and take off the exhaust pipe holders.
A. Carburetor Holders
B. Inlet Pipes
A. Nuts
B. Holder
.Take off the holders from the inlet pipes.
.Remove the muffler mounting bolt and nut (rear step
bracket).
.Remove the muffler.
I nstal/ation
.Install the carburetor holder so that the pipe is upward.
.Install the holder clamps as shown being careful of the
screw position and the screw head direction.
I nstal!ation
.Installation is the reverse of removal.
.Replace the exhaust gaskets.
1 .Holder Clamp
2. Screw
3. Screw Head
4. Stopper