Filter
Top Products
11-10 BRAKES
O Pullout the pistons by hand.
A. Rear Caliper
B. Apply compressed air.
Assembly Notes
.Apply brake fluid to the cylinders, pistons, and fluid
seals, and push the pistons into the cylinders by hand.
Take care that neither the cylinder nor the piston skirt
get scratched.
O For the rear caliper, install the dust seal around the
piston and push them into the cylinder. Check that the
dust seal is properly fitted into the grooves in the piston
and caliper body.
.Remove the following.
Dust Seals
Fluid Seals
.Repeat the previous step to remove the pistons from the
other side of the caliper body.
Front Caliper
Rear Caliper Disassembly
.Disassemble the rear caliper in the same manner as the
front caliper (see Front Caliper Disassembly). Note the
additional information below.
0 Remove the piston dust seal before piston removal.
Rear Caliper
B. Dust Seal
A. Rear Caliper
3. Dust Seal
1. Piston
2. Fluid Seal
.Be sure to install the followinQ.