Filter
Top Products
15-20 ELECTRICAL SYSTEM
IC Igniter Internal Resistance
Range: kQ
Electric Starter System
Starter Motor Removal
.Remove the fuel tank (see Fuel System chapter).
.Remove the terminal nut of starter motor wiring and take
out the mounting bolts.
O Using the socket wrench (special tool: 57001 -1268)
makes work easy.
.Pull the starter motor upwards with twisting motion.
A. Starter Motor
IC Igniter Terminal
Q
(I
([
(I
Starter Motor Installation
""'
Q
([
{t
(If
.When installing the starter motor, clean the starter motor
legs and crankcase where the starter motor is grounded.
.Applya small amount of engine oil to the O-ring.
.Tighten the following fasteners to the specified torque
(see Exploded View).
Starter Motor Mounting Bolt
Terminal Nut
NOTE
ONo measurement is needed on H terminal.
Starter Motor Disassembly
.Remove both end covers and pull the armature out of
voke.