Filter
Top Products
FUEL SYSTEM 2-9
~
/
~
Carburetor Disassembly / Assembly
Float Height
Standard:
11 :t2 mm
NOTE
0 Do not push the needle rod in during the float height
measurement.
Carburetor Removal
CD
*If the needle jet is damaged, replace the carburetor
.Remove the following.
Fuel Tank (see Fuel Tank Removal)
Surge Tank (see Surge Tank Removal)
Air Cleaner Housing (see Air Cleaner Housing
Removal)
Idle Adjuster
Fuel Hoses
.Loosen the carburetor clamps and remove the
carburetors.
Carburetor Inspection
Carburetor Installation
.Install the holder clamps as shown being careful of the
screw position and the screw head direction (see
Engine Top End chapter).
.Slide the starter plunger lever right to left to check that
the starter plungers move smoothly and return with
spring tension.
*If the starter plungers do not work properly, replace the
carburetors.