Filter
Top Products
15-12 ELECTRICAL SYSTEM
A. Silicone Sealant Applied Area
A. Flywheel Holder: 57001 -1 31 3 C. Rotor Bolt
B. Rotor
.Apply silicone sealant to the left inner cover bolt.
.Threads the rotor puller (special tool) and the rotor
puller (special tool) onto the alternator rotor.
.Holding the rotor puller, turn the rotor puller until the
alternator rotor is forced off the end of the crankshaft.
~
1. Left Inner Cover
2. Apply a non-permanent locking agent.
A. Rotor Puller: 57001 -1216
B. Rotor Puller: 57001 -1277
Alternator Rotor Removal
.Place the jack (special tool) under the frame to steady
the motorcycle.
.Place a suitable container under the alternator cover.
.Remove the alternator cover.
.Wipe oil off the outer circumference of the rotor.
.Hold the alternator rotor steady with the flywheel holder
(special tool), and remove the rotor bolt.
Alternator Rotor Installation Notes
.Clean the following portions with an oil-less cleaning
fluid such as trichloroethylene or acetone.
These cleaning fluids are usually highly flammable and
harmful if breathed for prolonged periods. Be sure to
heed the fluid manufacturer's warnings.