Filter
Top Products
11-12 BRAKES
Lining Wear
.For front caliper pad inspection, remove the pad spring
(see Front Caliper Removal).
.For rear caliper pad inspection, remove the rear caliper
(see this chapter).
.Remove the pad cover.
*If the lining thickness of either pad is less than the
service limit replace both pads in the caliper as a set.
Pad Lining Thickness (front and rear)
Standard: 4 mm
Service Limit: 1 mm
1. Springs
2. Clips
3. Pad Pins
4. Outside
.Remove the brake pads .
Installation Notes
.Push the caliper pistons in by hand as far as they will
go.
.Install the pad pin(s) and clip(s) as shown. The clip(s)
must be "outside" of the pads.
A. Spring
B. Pad Pin
.For the rear caliper, install the springs, pad pins, and
clips on the original position shown (see Rear Brake
Pad Removal).
A. Service Limit