Filter
Top Products
ELECTRICAL SYSTEM 15-11
Charging System
Alternator Cover Removal
.Remove the lower fairing.
.Set a suitable container under the engine.
.Remove the alternator cover bolts, using the socket
wrench (special tool: 57001-1268).
A. Alternator Cover Bolt
.Remove the alternator cover.
.Check the electrolyte level after charging.
Alternator Cover Installation
.Replace the gasket with a new one.
.Run the stator lead as shown.
.Apply silicone sealant to the stator lead grommet.
.Apply silicone to the crankcase halves mating surface
on the front and rear sides of the cover mount.
1. Apply silicone sealant