Filter
Top Products
BRAKES 11-7
Brake Pedal
Brake Pedal Position Adjustment
.Check that the brake pedal is in the correct position.
Pedal Position
Standard:
About 43 mm below from center
of brake pedal shaft
1. Hold the brake applied.
2. Quickly open and close the valve.
3. Release the brake.
A. Footpeg
B. Brake Pedal
c. Pedal Position
B. Bleed Valve
A. Caliper
.When air bleeding is finished, install the rubber caps on
the bleed valve, and check that the brake fluid is filled
to the upper level line marked in the reservoir (handlebar
turned so that the reservoir is level) .
NOTE
0 Usually it is not necessary to adjust the pedal position,
but always adjust it when the master cylinder is
disassembled.
O If the pedal position cannot be adjusted by turning the
clevis, the brake pedal may be deformed or incorrectly
installed.
.When the brake pedal is in its rest position, measure the
length (A) indicated in the figure.
*If the length (A) is not within the specified length,
adjust a nut.
@
1 .Master Cylinder
2. Locknut
3. Clevis