Filter
Top Products
ELECTRICAL SYSTEM 15-31
Meters, Gauges
Removal
.Remove the following.
Upper Fairing (see Frame chapter)
Headlight Unit
Speedometer Cable Upper End
Wiring Connectors
.Remove the meter unit by taking off the mounting nuts.
A. Pull the bulb.
Meter, Gauge Assembly Note
.Install each lead on the original position shown.
A. Meter Mounting Nuts
A. W/Y Lead
B. BK/Y Lead
c. BR Lead
D. BK Lead
Bulb Replacement
.To remove the wedge-base type bulb, pull the bulb out
of the socket.
T achometer I nspection
.Check the tachometer circuit wiring (see Tachometer
Circuit and Wiring Inspection).
*If all wiring and components other than the tachometer
unit check out good, the unit is suspect. Check the unit
as shown.
.Remove the surge tank (see Fuel System chapter).
.Remove the BK lead of the ignition coil.
.Turn the ignition switch ON.
.Open or connect the BK lead to the battery positive
terminal using an auxiliary lead. Then the pointer
should flick.
.Turn the ignition switch OFF.
*If the pointer does not flick, replace the tachometer unit.