Filter
Top Products
ELECTRICAL SYSTEM 15-29
Cooling Fan Circuit
Fuel Pump
The pump operates when the starter button is pushed
on or the engine is running.
.Refer to the Starter Motor section for the Fuel Pump
Wiring Diagram.
When fuel level in the float bowl is low, the fuel
pump operates to supply fuel into the float bowl.
When the fuel reaches a certain level, the fuel pressure
rises, and the fuel pump stops.
A. Pump Relay
B. Fuel Pump
1. Radiator Fan
2. 2-pin Connector
3. Starter Relay
4. Fan Fuse 10A
5. Junction Box
6. Fan Switch
7. Radiator
8. Main Fuse 30A
9. Battery
R emo val/ I nstallation
.Refer to the fuel system chapter.
Fuel Pump Relay Inspection
.Remove the side cover assembly (see Frame chapter)
and take out the fuel pump relay.
.Set the hand tester (special tool: 57001 -983) to the x
1 kQ range and make the measurements shown in the
table.
* If the tester readings are not as specified, replace the fuel
pump relay.
* If the tester readings are normal, check the fuel pump
operation.
CAUTION
Use only Hand Tester 57001-983 for this test. An
ohmmeter other than the Kawasaki Hand Tester may
show different readings.
If a megger or a meter with a large-capacity battery is
used. the pump relay will be damaged.