Filter
Top Products
WHEELS / TIRES 9-11
Speedometer Gear Housing
Hub Bearings
Disassembly and Assembly
NOTE
Olt is recommended that the assembly be replaced rather
than attempting to repair the components.
Removal
.Remove the following.
Wheel (see this chapter)
Oil Seals and Circlips
.Use the bearing remover (special tool) to remove the
hub bearings
I -\-1
.Install the speedometer gear housing so that it fits in the
speedometer gear drive notches (see Front Wheel
Installation).
Lubrication
.Clean and grease the speedometer gear housing.
m
1)'
t
~
/
""'
L- ~
1 .Bearing Remover Shaft: 57001 -1265
2. Bearing Remover Head
1. Speedometer Gear Housing
2. Grease.
/ nsta//ation
.Install the bearings by using the bearing driver set
(special tools: 57001-1129).
NOTE
0 Install the bearings so that the marked or sealed side
faces out.
Lubrication
NOTE
OSince the front and rear hub bearings are packed with
grease and sealed, they are not required to be removed
for lubrication. Clean and grease the rear hub bearings.