Filter
Top Products
FUEL SYSTEM 2-5
Throttle Grip and Cables
Throttle Cable Adjustment
.Check throttle grip free play.
A. Accelerator Cable
B. Adjuster
Co Locknut
Do Decelerator Cable
.Loosen all the adjuster and slide both throttle cables at
the carburetor to obtain the specified free play.
.Tighten the locknuts.
.Check that the throttle linkage lever stops against the
idle adjusting screw with the throttle grip released and
stops against the carburetor stopper with the throttle
grip opened.
A. Throttle Grip Free Play
Throttle Grip Free Play
Standard: 2 -3 mm
*If the free play is incorrect, loosen the locknut and turn
the adjuster of the accelerator cable until the proper
amount of throttle grip play is obtained.
A. Locknut B. Adjuster
.Tighten the locknut against the adjuster securely.
*If the play can not be adjusted by using the adjuster at
the throttle grip, use the adjusters at the carburetors.
.Remove the fuel tank (see Fuel Tank Removal).
.Remove the surge tank (see Surge Tank Removal).
.Screw in the adjuster fully at the throttle grip and tighten
the locknut.