Filter
Top Products
FINAL DRIVE 10-7
Rear Sprocket Removal
.Remove the rear wheel (see Wheels/Tires chapter)
NOTE
OSprocket wear is exaggerated for illustration.
Sprocket Teeth
Worn T ooth
(Engine Sprocket)
Worn Tooth
(Rear Sprocket)
.Pullout the rear wheel coupling from the rear wheel.
.Remove the rear sprocket nuts.
.Remove the rear sprocket.
Direction of rotation
Rear Sprocket Installation
.Installation is the reverse of removal. Note the follow-
ing.
O Install the sprocket facing the tooth number marking
outward.
Coupling Installation
.Grease the following.
Ball Bearing
Coupling Grease Seal
Coupling Internal Surface
A. Tooth Number Marking
.Tighten the rear sprocket nuts to the specified torque
(see Exploded View).
.If the stud bolt is to be replaced. apply a non -permanent
locking agent to the lower half of the stud bolt.
.Install the rear wheel (see Wheels/Tires chapter).
A. Grease here.
Rear Sprocket Wear
.Visually inspect the rear sprocket teeth.
*If the teeth are worn as illustrated. replace the sprocket,
and inspect the drive chain and engine sprocket (see
Drive Chain Wear Inspection).