Filter
Top Products
3 - DIRECT-TO
63
190-00357-00 Rev E
Cancelling / Manual Course
Cancelling Direct-To Navigation
Once a direct-to is activated, the unit provides
navigation guidance to the selected waypoint until the
direct-to is manually cancelled or replaced by a new
active leg or direct-to.
To cancel a direct-to, select a new direct-to
waypoint, activate a flight plan or select the
“Cancel Direct-To NAV?” option.
To cancel a direct-to:
1. Press the direct-to key to display the Select
Direct-to Waypoint Page.
2. Press MENU to display the Direct-to Options
menu.
3. With “Cancel Direct-To NAV?” highlighted,
press ENT. If a flight plan is still active, the
unit resumes navigating the flight plan along
the closest leg.
Specifying a Course to a Waypoint
When you perform a direct-to, the unit sets a
direct geodetic course to the selected waypoint. You
can also manually define the course to the selected
waypoint, using the course field (“CRS”) on the Select
Direct-toWaypointPage.
The “CRS” field allows you to define the
course to a selected waypoint. Use the small
and large right knobs to enter the desired
course.
To manually define the course to a waypoint:
1. Press the direct-to key.
2. Use the small and large right knobs to select
the desired waypoint.
3. Press ENT to confirm the selected waypoint,
then turn the large right knob to highlight
the course (“CRS”) field.
4. Turn the small and large right knobs to select
the desired course and press ENT.
5. Press ENT again to begin navigation using the
selected waypoint and course.