Filter
Top Products
9 - AUX PAGES
186
190-00357-00 Rev E
NOTE: The CDI scale is always displayed in nautical
miles, regardless of the current distance units of mea-
sure selected on the Units / Position Page.
To change the ILS CDI selection:
1. Select “CDI / Alarms” from the Setup Page.
2. Turn the large right knob to highlight the
“ILS CDI Capture” field.
3. Turn the small right knob to select “Auto” or
“Manual”, as desired. Press ENT to accept the
selection.
NOTE: Installations with certain autopilots, such as the
KAP 140 and KFC225, do not allow automatic ILS CDI
switching.
“Auto” ILS CDI Capture switches the CDI
output from GPS to the VLOC receiver as you
intercept the final approach course.
To set the arrival alarm and alarm distance:
1. Select “CDI / Alarms” from the Setup Page.
2. Turn the large right knob to highlight the
“On”/”Off” field (left-hand side of the field
directly below “Arrival Alarm”).
3. Turn the small right knob to select “On” or
“Off”, as desired. Press ENT to accept the
selection.
4. The flashing cursor moves to the alarm dis-
tance field (to the immediate right of “On” or
“Off”). To enter an arrival alarm distance, use
the small and large right knobs to enter
the desired alarm distance. Press ENT when
finished.
Units / Position
To set the magnetic variation:
1. Select “Units / Position” from the Setup Page 1.
2. The flashing cursor highlights the heading mode
field. Turn the small right knob to select the
desired heading mode: Magnetic, True, or User.
3. If User Heading is selected, the flashing cursor
will highlight the Heading field. Turn the small
right knob to the desired heading values,
hemisphere and then degrees.
NOTE: Manual (User) selection of the heading value is
available for units with SW Version 3.30, or later.
Setup 1 Page