Filter
Top Products
9 - AUX PAGES
173
190-00357-00 Rev E
Flight Planning
To perform Crossfill
Select“Crossll?”fromtheDefaultNAVPage,
Flight Plan Catalog page, Active Flight Plan page,
or the User Waypoint page by pressing MENU,
scrolling down to “Crossfill” with the large right
knob and then pressing ENT. On the Aux Flight
Planning page scroll down to “Crossfill” with the
large right knob, and then press ENT.
• Automatic Crossfill Operation: If both
units are set to automatic, a change in the
activeightplan,orVNAVparameters,onone
unit can also be seen in the other. Initiating
a direct-to course to a waypoint on one unit
also initiates a direct-to course to the same
waypoint on the other unit.
If one unit is set for automatic crossfill and
the other is set for manual crossfill, then only
the auto unit automatically sends data to the
manual unit. In this configuration, the auto
unit could be thought of as the master unit.
• Manual Crossfill Operation: If manual
operation is desired, the pilot must invoke
all transfers from that unit. When a unit is
configured for automatic transfer, a manual
transfer can also be done on command. If
either of the messages “data transfer error” or
“data transfer cancelled” are received during
an automatic or manual transfer, the pilot
must force another transfer.
To transfer flight plans or user waypoints to/from a
second 500W-Series (or 400W-Series) unit:
1. While viewing the default Nav page, Flight Plan
Catalog, Active Flight Plan page, User Waypoint
page,
or the User Waypoint page by pressing
MENU, scrolling down to “Crossfill” with the
large right knob and then pressing ENT. On
the Aux Flight Planning page scroll down to
“Crossfill” with the large right knob, and then
press ENT.
2. Turn the large right knob to highlight the
Method field. Turn the small right knob to
select “Auto” or “Manual”. “Auto” automati-
cally transfers any selection of (or any change
to) a direct-to destination or active flight
plan, including VNAV parameters, to a second
500W/400W-Series Garmin unit.
3. The flashing cursor highlights the transfer data
option (TRANSFER) field. Turn the small right
knob to display a window of available data
options: