Filter
Top Products
27
1 - COM
190-00357-00 Rev E
To select a COM frequency for any airport in your
flight plan:
1. Select the NAVCOM Page from the NAV page
group. (See Section 2, or press and hold CLR,
then turn the small right knob until the
NAVCOM Page appears.)
The NAVCOM Page provides a frequency list
for all the airports (departure, en route and
arrival) along your active flight plan.
2. Press the small right knob to place the cursor
on the airport identifier field. To the left of this
field appears Departure, En Route or Arrival
— depending on the placement of the dis-
played airport within your flight plan.
3. Turn the small right knob to display a window
listing the airports in your flight plan. Continue
turning the small right knob to select the
desired airport.
4. Press ENT to return to the NAVCOM Page with
the frequencies for the selected airport.
5. Turn the large right knob to highlight the
desired frequency.
6. Press ENT to place the highlighted frequency
in the standby COM window field.
To select a COM frequency for any airport in the
database:
1. Select the Airport Frequencies Page from the
WPT page group. (See Section 6, or turn the
large right knob to select the WPT page
group. Then turn the small right knob until
the Airport Frequencies Page appears.)
Use the Airport Frequencies Page to retrieve
a frequency list for ANY airport in the
Jeppesen NavData database.
2. Press the small right knob to place the cursor
on the airport identifier field.
3. Use the small and large right knobs to enter
the identifier of the desired airport. Press ENT
when finished.
4. Turn the large right knob to highlight the
desired frequency.
5. Press ENT to place the highlighted frequency
in the standby COM window field.
Auto-Tuning from Flight Plan
GNS 530W only