Filter
Top Products
5 - PROCEDURES
110
190-00357-00 Rev E
to do so when cleared for the approach. See
“Approaches with Procedure Turns” in this
section, step #4 for a description of this opera-
tion.
3. As you approach the IAF (SHUTR), a waypoint
alert (“Left to 032° in x sec”) appears in the
lower right corner of the screen.
As you approach the IAF, “Left to 032° in
x sec” appears, followed by “Left to 032°
now” when it’s time to begin the turn to the
outbound course.
4. If you haven’t already done so, press the VLOC
flip-flop key to activate the ILS frequency.
If you forget this step, the unit displays a
reminder message (within 2 NM of the FAF)
to activate the ILS frequency.
5. As the distance (DIS) to the IAF approaches
zero, the alert is replaced by a turn advisory
(“Left to 032° now”).
6. Fly the outbound course (030°), keeping the
needle centered on the external CDI (or HSI).
7. Once you have flown approximately one minute
past SHUTR intersection, the alert message
“Right to 075° in x sec” appears in the lower
right corner of the screen (if you haven’t
already begun the procedure turn).
“Right to 075° in 7 sec” appears in the lower
right corner of the screen to remind you to
initiate the procedure turn.
8. Turn right to a heading of 075° to initiate the
procedure turn. Messages displayed during
turn provide roll steering guidance. (The pro-
cedure turn is displayed on the Map Page and
indicated as the active leg on the Default NAV
and Active Flight Plan pages.) The external CDI
needle starts moving to the left.
DO NOT USE FOR
NAVIGATION
ILS Approach
GNS 530W only