Filter
Top Products
12 - MESSAGES
ABBREVIATIONS &
NAV TERMS
203
190-00357-00 Rev E
VLOC remote transfer key is stuck — (GNS 530W
only)TheremoteVLOCtransferswitchisstuckinthe
enabled (or “pressed”) state. Try pressing the switch again
to cycle its operation. If the message persists, contact your
Garmin dealer for assistance.
VLOC transfer key stuck — (GNS 530W only) The
VLOC flip-flop key is stuck in the enabled (or “pressed”)
state. Try pressing the VLOC flip-flop key again to cycle
its operation. If the message persists, contact your Garmin
dealer for assistance.
Waypoint already exists — The name you have entered
for a user waypoint already exists in memory.
Waypoint(s) have been replaced — One or more user
waypoints were updated during a unit-to-unit crossfill
operation.
Waypoint memory is full — You have used all 1000 user
waypointlocationsinthe500W-seriesunitmemory.Delete
unwanted waypoints to make room for new entries.
Turn Advisory and Arrival Annunciations
The following annunciator messages may appear in the
lower right corner of the 500W-series unit display:
Arriving at waypoint — Arriving at the destination
waypoint for the active leg.
Hold direct — “Direct”holdingpatternentry.
Hold parallel — “Parallel” holding pattern entry.
Hold teardrop — “Teardrop” holding pattern entry.
Left to xxx° in xx sec — Turn advisory. Turn to the indi-
cated heading by the time shown.
Left to xxx° now — Turn advisory. Turn to the indicated
heading by the time shown.
Next DTK xxx° in xx sec — Waypoint alert. Prepare to
turn to the indicated heading upon waypoint passage.
PTK end in xx sec — Parallel Offset is terminating.
Right to xxx° in xx sec — Turn advisory. Turn to the
indicated heading by the time shown.
Right to xxx° now — Turn advisory. Turn to the indicated
heading by the time shown.