Filter
Top Products
MAINTENANCE
2.22
A
4. Loosen clamp and remove air filter assembly.
Gasket
Cover
Pre-filter
Main Element
Ill.1
Carb Boot
Cleaning:
5. Slip the pre-filter element off of main element.
Clean the pre filter with high flash point solvent,
followed by hot soapy water.
6. Rinse and dry thoroughly.
7. Inspect element for tears or damage.
8. Apply foam filter oil or clean engine oil and
squeeze until excess oil is removed.
9. Inspect main filter and replace if necessary. If the
filter has been soaked with fuel or oil it must be
replaced.
Installation:
10. Reinstall pre-filter element over main filter. Be
sure the element covers entire surface of main
filter without folds, creases, or gaps.
11. Reinstall filter on main filter mount. Place filter
clamp over the assembly and tighten.
NOTE: Apply a small amount of general purpose
grease to the sealing edges of the filter before
reinstalling.
Filter Clamp
Ill.2
Main Filter
Filter Support
Front
Air Box
Proper Filter Placement
Ill.3
NOTE: The air filter should rest on the filter support.
Proper placement of the air filter is important to
prevent rattles and air leaks. See Illustration above.
12. Install air box cover and secure with clips.
AIR BOX SEDIMENT TUBE
Periodically check the air box drain tube located
toward the rear of the machine. Drain whenever
deposits are visible in the clear tube.
1. Remove drain plug from end of sediment tube.