FUEL SYSTEM/CARBURETION
4.8
VENT SYSTEMS - CV
CARBURET
OR
The carburetor float bowl vent lines supply
atmospheric pressure to the float bowl. The lines
must be free of kinks, restrictions and be properly
routed. This allows fuel to flow in the proper amount
and prevents contaminants from entering the
carburetor.
MIKUNI CV CARB
OPERA
TION
The constant velocity carburetor incorporates a
mechanically operated throttle plate and a vacuum
controlled slide valve (vacuum slide). The venturi
cross-sectional area in the carburetor bore is
increased or decreased automatically by the vacuum
slide, which moves according to the amount of
negative pressure (less than atmospheric) present in
the venturi.
A diaphragm attached to the top of the vacuum slide
is sealed to the slide and to the carburetor body
forming two chambers. The chamber above the
diaphragm is connected to the venturi area by a drilled
orifice in the center of the vacuum slide. The chamber
below the diaphragm is vented to atmospheric
pressure by a passage on the air box side of the
carburetor. A spring, installed in the center of the
vacuum slide, dampens the slide movement and
assists the return of the slide.
=AirFlow
= Low Pressure
Air Box
Pressure
From
Air Box
Venturi
Throttle
Plate
Diaphragm
Vacuum
Slide
Low Pressure
From Venturi
CARBURETOR OPERATION CONT’D
When the throttle plate is opened and engine speed
begins to increase, the pressure in the venturi (and
therefore in the chamber above the diaphragm)
becomes significantly lower than atmospheric.
Atmospheric pressure in the chamber below the
diaphragm forces the diaphragm upward, raising the
slide against spring pressure. When the pressure
above and below the diaphragm are nearly equal, the
slide moves downward under spring pressure.
Raising or lowering the slide increases or decreases
the cross sectional area in the venturi, and therefore
the air velocity in the venturi is kept relatively constant.
This provides improved fuel atomization and optimum
fuel/air ratio.
=AirFlow
= Low Pressure
Low Pressure
From Venturi
From
Air Box
Throttle
Plate
Diaphragm
Vacuum
Slide
Venturi
Note: Diagrams are for explanation of theory only, and are not true
representations of Mikuni BST carburetor.
PILOT (IDLE AND SLOW)
SYSTEM
This system supplies fuel during engine operation
with throttle valve closed (1) or slightly opened. The
fuel from float chamber (2) is metered by pilot jet (3)
where it mixes with air coming in through pilot air jet
(4). The mixture then goes up through pilot passage
to pilot screw (5). A part of the mixture is discharged
into the main bore out of bypass ports (6). The
remainder is then metered by pilot screw and
discharged into the main bore through pilot outlet (7).