Filter
Top Products
CLUTCHING
6.18
8. Pull bushing removal tool and adapter from puller
rod. Remove bushing from tool and discard.
NON--EBS -- DRIVE CLUTCH
MOVEABLE SHEAVE
-
BUSHING INSTALLA
TION
1. Place the Main Puller Adapter (#8) (PN 5020632)
onto the puller.
2. Apply Loctitet 680 (PN 2870584) to the back
side of new bushing. Push bushing into center of
sheave on tower side by hand.
Bushing (PN 3576504)
Loctitet 680 (PN 2870584)
3. Insert the Clutch Bushing Installation Tool (#2) (PN
5020628) into center of sheave and with towers
pointing away from vise, slide sheave onto puller
rod.
4. Install nut on puller rod and hand tighten. Turn
barrel to apply additional tension if needed.
5. Turn sheave and barrel together
counterclockwise until bushing is seated.
6. Remove nut from puller rod and set aside.
7. Remove sheave from puller.
8. Remove installation tool.
NON--EBS DRIVE CLUTCH
COVER - BUSHING REMOV
AL
Main Puller
Adaptor (#8)
Piston Pin Puller
(PN 2870386)
1. Install the Main Puller Adapter (#8) (PN 5020632)
onto the Piston Pin Puller (PN 2870386).
2. From outside of clutch cover, insert the Drive
Cover Bushing Remover (#3) (PN 5020629)into
cover bushing.
3. With inside of cover toward vise, slide cover onto
puller.
4. Install nut onto puller rod and hand tighten. Turn
puller barrel to increase tension as needed.