Filter
Top Products
ELECTRICAL
10.9
SPEEDOMETER REMOVAL
1. Remove the three screws that secure the
headlight pod cover and disconnect the wire
connectors from the instrument cluster and work
light switch.
2. Push the instrument cluster out from the backside
of the pod, while securely holding the pod.
Instrument Cluster
Pod
Push Instrument
Cluster Outward
Rubber Mount
*NOTE: Do not remove the rubber grommet in the
pod. Only remove the rubber grommet if necessary.
SPEEDOMETER INSTALLATION
1. Spray a soap and water mixture onto the outer
surface area of the instrument cluster. This will
help the instrument cluster slide into the pod
assembly more easily.
2. Be sure the rubber grommet inside the pod is fully
installed and that the indexing key is in the
headlight pod keyway.
Align Index Points
3. Hold the pod assembly securely and insert the
instrument cluster into the pod assembly. Twist
the instrument cluster gently in a clockwise
motion to properly seat the instrument cluster into
the pod assembly. Apply pressure on the bezel
while pressing down on the instrument cluster.
*NOTE: Do not allow alcohol or petroleum products
to come in contact with the instrument cluster lens.